autodesk inventor 2015 set default metric

If you are not able to locate below the software product and version that you have licensed and installed, please contact License. Remember that you are bound by the specific software license agreement that applies to each software product you have licensed and installed. These agreements are provided here for reference purposes only. Unless you have another agreement directly with Autodesk that controls and alters your use of Autodesk software products, the terms and conditions of the software license agreement that accompanies the software product apply to you.įor your convenience, we have posted below the software license agreements for some of our software products and versions. Under assembly select 'Standard (mm).iam' if you used the metric system or 'Standard (in. I used mm to model my parts so, I chose metric.

On the page that pops up (shown in the picture above) select 'English' or 'Metric' depending on what measurements you used. Please refer to the particular software product for the software license agreement applicable to that software. Open Inventor and select 'File' 'New' in the top left corner. We generally provide our software license agreements electronically within each software product as a “click through” license.

The terms of Autodesk's software license agreements may vary depending upon the specific software product and version that you licensed from Autodesk as well as the specific geographical region in which you obtained your software license. Rather, we license it to the end user under the terms of a software license agreement.

Autodesk inventor 2015 set default metric